Seismic Performance Enhancement of a Reinforced Concrete Building Using an RB-HDRC Base Isolation System
DOI:
https://doi.org/10.70609/g-tech.v10i2.9398Kata Kunci:
Base Isolation, RB-HDRC, Nonlinear Time History Analysis, Seismic PerformanceAbstrak
This study investigates the seismic performance enhancement of a four-story reinforced concrete building retrofitted with a Rubber Bearing-High Damping Rubber Core (RB-HDRC) base isolation system. A three-dimensional numerical model was developed and subjected to nonlinear time-history analysis under two design earthquake levesl (BSE 1-E and BSE 2-E). The results indicate that the base isolation system significantly reduces seismic demands compared to the fixed-base condition. Peak base shear was reduced by approximately 48% at the BSE-1E level and by 52% at the BSE-2E level. Roof acceleration decreased by about 76% and 79% at the BSE 1-E and BSE 2-E levels, respectively. The maximum interstory drift ratio was also reduced, demonstrating improved deformation control in the isolated system. Furthermore, the number of plastic hinges decreased significantly, while the energy dissipation capacity increased due to the hysteretic behavior of the RB-HDRC isolator. These findings demonstrate that RB-HDRC base isolation effectively enhances structural resilience and represents a promising strategy for improving the seismic performance of reinforced concrete buildings.
Referensi
Apostolidi, E., Dritsos, S., Giarlelis, C., Jara, J., Sutcu, F., Takeuchi, T., & White, J. (2021). Seismic Isolation and Response Control. In Seismic Isolation and Response Control. International Association for Bridge and Structural Engineering (IABSE). https://doi.org/10.2749/sed019
Choun, Y. S., Park, J., & Choi, I. K. (2014). Effects of mechanical property variability in lead rubber bearings on the response of seismic isolation system for different ground motions. Nuclear Engineering and Technology, 46(5), 605–618. https://doi.org/10.5516/NET.09.2014.718
Fakih, M., Hallal, J., Darwich, H., & Damerji, H. (2021). Effect of lead-rubber bearing isolators in reducing seismic damage for a high-rise building in comparison with normal shear wall system. SDHM Structural Durability and Health Monitoring, 15(3), 247–260. https://doi.org/10.32604/SDHM.2021.015174
Fujino, Y., Siringoringo, D. M., Kikuchi, M., Kasai, K., & Kashima, T. (2019). Seismic monitoring of seismically isolated bridges and buildings in Japan—case studies and lessons learned. In Springer Tracts in Civil Engineering (pp. 407–447). Springer. https://doi.org/10.1007/978-3-030-13976-6_17
Imran, I., Siringoringo, D. M., & Rainayana, S. S. (2024). Seismic evaluation and retrofit of a typical reinforced concrete hospital building in Indonesia with DCFP isolation system. Structures, 64. https://doi.org/10.1016/j.istruc.2024.106593
Kelly, J. M. (1999). The role of damping in seismic isolation. Earthquake Engineering & Structural Dynamics. 28(1), 3–20. https://doi.org/https://doi.org/10.1002/(SICI)1096-9845(199901)28:1
Makris, N. (2019). Seismic isolation: Early history. In Earthquake Engineering and Structural Dynamics (Vol. 48, Number 2, pp. 269–283). John Wiley and Sons Ltd. https://doi.org/10.1002/eqe.3124
Nasional, B. S. (2012). SNI 1726-2012 Tata cara perencanaan ketahanan gempa untuk struktur bangunan gedung dan non gedung. www.bsn.go.id
Nasional, B. S. (2013). Persyaratan beton struktural untuk bangunan gedung Badan Standardisasi Nasional. www.bsn.go.id
Nasional, B. S. (2019). SNI 2847-2019 Persyaratan Beton Struktural Untuk Bangunan Gedung dan penjelasan.
Nasional, B. S. (2019). SNI 1726-2019 Persyaratan Beton Struktural Untuk Bangunan Gedung.
Pianese, G., Habieb, A. B., Losanno, D., & Milani, G. (2025). Numerical investigation of high-damping rubber cores to enhance the damping performance of elastomeric seismic isolators RB-HDRC.
Pianese, G., Van Engelen, N., Tait, M., & Milani, G. (2024). Shake table tests on a rigid block isolated with high-damping unbonded fiber-reinforced elastomeric isolators. Structures, 64. https://doi.org/10.1016/j.istruc.2024.106595
Pianese, G., Van Engelen, N., Toopchi-Nezhad, H., & Milani, G. (2024a). An experimental and numerical insight into the unbonded and partially bonded high-damping fiber-reinforced elastomeric isolators. Soil Dynamics and Earthquake Engineering, 187. https://doi.org/10.1016/j.soildyn.2024.109016
Pianese, G., Van Engelen, N., Toopchi-Nezhad, H., & Milani, G. (2024b). High-damping fiber-reinforced elastomeric seismic isolator in different boundary conditions: An experimental insight. Engineering Structures, 300. https://doi.org/10.1016/j.engstruct.2023.117199
Pohl, H. R., Ingber, S. Z., & Abadin, H. G. (2017). Historical view on lead: Guidelines and regulations. In Lead: Its Effects on Environment and Health (Vol. 17, pp. 435–470). Walter de Gruyter GmbH. https://doi.org/10.1515/9783110434330-013
Robinson, W. H. (1982). Lead-Rubber Hysteretic Bearings Suitable for Protecting Structures During Earthquakes. In Earthquake Engineering and Structural Dynamics (Vol. 10).
American Society of Civil Engineers. (2017). Seismic Evaluation and Retrofit of Existing Buildings (ASCE 41-17). American Society of Civil Engineers. https://doi.org/https://doi.org/10.1061/9780784414859
Sheikh, H., Van Engelen, N. C., & Ruparathna, R. (2022). A review of base isolation systems with adaptive characteristics. In Structures (Vol. 38, pp. 1542–1555). Elsevier Ltd. https://doi.org/10.1016/j.istruc.2022.02.067
Tim Pusat Studi Gempa Nasional. (2022). Peta Deagregasi Bahaya Gempa Indonesia untuk Perencanaan dan Evaluasi Infrastruktur Tahan Gempa.
Unduhan
Diterbitkan
Terbitan
Bagian
Lisensi
Hak Cipta (c) 2026 Nur Khofifah, Ahmad Basshofi Habieb
Artikel ini berlisensi Creative Commons Attribution 4.0 International License.
